From yahoo Sent Mon, Jan 7th 2019, 12:49
From yahoo Sent Mon, Jan 7th 2019, 12:49
Hi Andy,
you find my answers written inline.
Best wishes
Dieter Doepfer
> Hi Dieter,
>
> Thanks. Are the outputs always a positive voltage?
The Gate and the pressure CV are always positive.
The position CV becomes slightly negative (about -1V with the scale control
fully CW) in the Hold Off mode when the position sensor is not touched.
> The Behringer Model D manual states that exceeding the rated
> input voltages can damage it.
>
> I have no way of knowing if that's true, because I haven't seen
> the schematics of that either, but I'd rather not rely on it
> being wrong, or on me not turning the scale knobs past 4, so I
> want to make up some fixed value attenuators, or similar, to make sure.
>
> Are the outputs direct from an op amp, or is there a resistor
> between each op amp and the output socket - or is it more
> complicated than that?
There are 10k potentiometers as attenuators at both CV outputs. The output
sockets are connected to the center terminals of the potentiometers.
> - Andy
------------------------------------
------------------------------------
------------------------------------
Yahoo Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Doepfer_a100/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/Doepfer_a100/join
(Yahoo! ID required)
<*> To change settings via email:
xxxxxxx_xxxx-xxxxxx@xxxxxxxxxxx.xxx
xxxxxxx_xxxx-xxxxxxxxxxxx@xxxxxxxxxxx.xxx
<*> To unsubscribe from this group, send an email to:
xxxxxxx_xxxx-xxxxxxxxxxx@xxxxxxxxxxx.xxx
<*> Your use of Yahoo Groups is subject to:
https://info.yahoo.com/legal/us/yahoo/utos/terms/